Dot Matrix Module Ignition Control Module Dot Matrix Module DIY Kit SCM Control Module for

Specification: Module Dimensions: Approx. 32 ×32 ×13 mm/ 1.26 ×1.26 ×0.51 inchAs the pictures show, the input port is in the left side of module, and the onput port is in the right left of that.When only control a single module, just need to connect the input port to CPU.When connect more modules, input port of the first module should connect CPU, onput port of that connects the input port of the second module, and the onput port of the second module connects the input port of the third module, and so on.Taking 51-Single Chip Micyoco as an example:VCC connects to 5VGND connects to GNDDIN connects to P2.2CS connects to P2.1CLK connects to P2.0 Package Includes: 1 Piece of PCB Board1 Piece of AS Dot Matrix LED Module2 Pieces of 1x8 Round Hole Female Header2 Pieces of 5P Looper Note: e don't connect VCC and GND inversely, lest the chip is burnt out. MCU-51 P0 port controls, the pull-up resistor must be connected, and the suggested resistance is about 4.7K-10K.e insert the dot matrix to the round hole block firstly, and then insert the round hole block to the PCB board for weing.e hold the side of dot matrix with words towards yourself, and the PIN of this side is on the order of 12345, from left to right. Giá sản phẩm trên Tiki đã bao gồm thuế theo luật hiện hành. Bên cạnh đó, tuỳ vào loại sản phẩm, hình thức và địa chỉ giao hàng mà có thể phát sinh thêm chi phí khác như phí vận chuyển, phụ phí hàng cồng kềnh, thuế nhập khẩu (đối với đơn hàng giao từ nước ngoài có giá trị trên 1 triệu đồng).....